· Jiri Skapa · VORTARIAN · 2 min read

VORTARIAN 4R2T-10G: Tested 10 GbE Network Cards, Switches and SFP+ Modules

Network cards, switches, SFP+ modules and cables tested with the VORTARIAN 4R2T-10G in long-term streaming runs without UDP packet loss.

10 GbE streaming test on the Efinix Titanium Ti375 N1156 Development Kit

The VORTARIAN 4R2T-10G streams I/Q data over two 10GBASE-SR links, FO1 and FO2. The UDP sender in the FPGA can load each link up to the full 10 Gb/s line rate. The hardware below was tested in long-term transfer runs on the VORTARIAN board and on the Efinix Titanium Ti375 N1156 Development Kit, running the same 10 GbE UDP firmware. No UDP packet loss and no problems with link establishment or stability were detected.

Network cards

CardPorts
Mellanox ConnectX-5 MCX512F-ACHT (HPE P13186-001)2× SFP28, 10/25 GbE
Mellanox ConnectX-4 Lx MCX4121A-ACUT (HPE 840140-001)2× SFP28, 10/25 GbE
Intel X520-DA2 (82599ES), 10Gtek2× SFP+, 10 GbE
Broadcom NetXtreme II BCM57810S, 10Gtek2× SFP+, 10 GbE
Marvell AQtion AQC100, ASUS XG-C100F1× SFP+, 10 GbE

With a dual-port card, one card receives both links. With the single-port Marvell card, one card receives one link, that is two of the four channels.

Switches

SwitchPorts
MikroTik CSS610-8G-2S+IN8× 1 GbE RJ45, 2× 10 GbE SFP+
Arista DCS-7050S-52-R48× 10 GbE SFP+, 4× 40 GbE QSFP+

SFP+ modules and cables

Optical modules, 10GBASE-SR, 850 nm, multimode:

  • Intel AFBR-710DMZ-IN1
  • TP-Link TL-SM5110-SR
  • 10Gtek 10GBASE-SR
  • FS 10GBASE-SR

Active optical cables: FS 10G SFP+ AOC, 5 m and 15 m.

Direct-attach copper: 10Gtek CAB-10SFP-P2M, 2 m passive, AWG30.

Other hardware with 10GBASE-SR or SFP+ is likely to work as well; the list above is what we have tested. The ports of the board are described in VORTARIAN 4R2T-10G Board Ports.

Written by

Jiri Skapa · Lead RF/FPGA engineer at JSE

Jiri has designed RF and signal-processing hardware and FPGA firmware since 2003, starting with receivers and signal-processing boards for radar systems. He holds a master's degree in radio engineering from the Czech Technical University in Prague.

LinkedInGitHubAbout JSE

Share:
Back to Blog